LOGIC PULSER

 

The K&H LP-540H logic pulser is a very effective tool for inspecting and repairing logic circuits. It can directly inject a signal into the logic circuits neither removing the IC nor breaking the circuits. Using the logic probe as a monitor, you not only know the wiring errors but also check out mal-functional components.

Logic Pulser can produce a 10µs pulse signal at 100 mA load. The signal frequency can be switched to either 0.5Hz or 400Hz as a result the LP-540H is a fairly powerful pulser.

Moreover, the Logic Pulser can produce a 90% high digital signal at square wave output terminal. It is easier to observe and trace circuits by using oscilloscope. With a sync. input, it’s able to produce an external synchronized signal.

 

• Sync input impedance : 1Mohm
• Pulse repetition rate : 0.5pps / 400pps
• Pulse width in pulser output at 100mA load : 10µs
• Output current
• (1)pulser mode : 100mA sink / source
• (2)square wave output : 5mA sink / source
• Power supply protection : ± 25V / 25 sec
• Output protection : ± 35V /15 sec
• Maximum allowable supply voltage : ± 20V
• Operating supply voltage range : 3~5V
• Max. Output allowable connecting voltage : ± 35V
• Free air operating temperature range : 0~50°C
• Max. sync input voltage : ±120V / 15sec
• Size : 212 x 26.5 x 18mm
• Weight : 65g